CF ChatterFix
Log In Start Free
Preventive Maintenance

Engine Stand Tooling & Fastener Control

An engine stand is a configuration workplace. The serial, the procedure revision, and a complete tool count are the job. A torque taken from memory is the defect.

Interval Weekly
Est. Duration 1.5 hrs
Steps 5
Applies To Launch Vehicle Production

The Procedure

The steps ChatterFix schedules for this PM. Every step is a checkable item on the work order — a technician can speak their way through it without touching a keyboard.

  1. Account for every tool on the shadow board before the stand is released
  2. Verify torque tooling on the stand is inside its calibration date
  3. Inspect lift interface, grounding and alignment datums
  4. Confirm the work order names the engine serial and the procedure revision
  5. Stop if a torque value is being taken from memory rather than the released sheet

Why This PM Exists

An engine stand is a configuration workplace. The serial, the procedure revision, and a complete tool count are the job. A torque taken from memory is the defect.

What Skipping It Looks Like

Tools migrate off the shadow board, a socket past calibration stays because it still fits, and the record says the engine was built to the sheet it was not built to.

Setting the interval

Every build week. Calibration date and tool count are closeout items. A missing tool holds the engine.

Equipment This Covers

Additive Manufacturing Cell 21 PMs Backhoe Loader 7 PMs Box Truck 13 PMs CNC Machining Center 10 PMs Chiller 10 PMs Clean Assembly Booth 14 PMs Combine Harvester 11 PMs Die & Tooling 2 PMs Emergency Generator 10 PMs Engine Vertical Stand 12 PMs Farm Tractor 7 PMs Forklift 12 PMs Irrigation Pump & Pivot 13 PMs Laminator 9 PMs Mold & Tooling 8 PMs Proof Test Stand 15 PMs Service Van 33 PMs Tractor Unit 10 PMs

Common Questions

How often should this PM run?
Weekly. Every build week. Calibration date and tool count are closeout items. A missing tool holds the engine.
How long does it take?
Budget about 1.5 hours for a technician working to the standard procedure. ChatterFix uses that estimate for capacity planning, then learns your plant's actual time from completed work orders.
What happens if we skip it?
Tools migrate off the shadow board, a socket past calibration stays because it still fits, and the record says the engine was built to the sheet it was not built to.
Can I use this checklist in ChatterFix?
Yes — this exact procedure ships in the Launch Vehicle Production industry pack. Pick your industry at signup and it is scheduled on the right assets automatically, with no configuration.

Related Procedures

Additive Machine Filter & Atmosphere Check Every 2 weeks Circumferential Weld Parameter Audit Weekly Clean Booth Particle & FOD Audit Weekly FOD and Tool Control Audit Weekly High-Energy Exclusion Verification Monthly LOTO Program Verification Monthly

Stop Retyping Your PM Library

This procedure — and every other PM for your industry — is already built into ChatterFix. Pick your industry and it lands on the right equipment, on the right interval, in about three minutes.

Start Free Browse All Procedures